Battery Type/'s
-Lithum 100AH 3.3KW Charger-Lithum 200AH 3.3KW Charger
-Lithum 100AH 6.6KW Charger
-Lithum 200AH 3.3KW Charger
Installing charger
The new charger mounts in relatively the same location. For non-air conditioner vehicles, the charger mounts as shown in these images:
For air conditioner vehicles, the charger mounts as shown in this image:
Note all wiring is setup for rear mounting. Cut wire to desired length when mounting charger in front.
Larger black wire is the battery negative and will but splice to existing black wire going to the old charger. If old charger has a connector this wire would be white. As an alternative this can be attached to the switched side of the disconnect switch.
The larger red wire is for the battery pack positive and will but splice to existing red wire going to the old charger. If old charger has an existing inline connector, it can be cut off and removed.
The three 12ga wires (red, black and green) are the AC input wires. These splice to the same colored wires. If old charger has an existing inline connector, it can be cut off and removed. Splice wires with matching colors.
The small wires with the gray sheathing are for CANBUS. The three wires will splice to the same colored wires. If your old charger had a small box this box is removed. This was a CANBUS converter not needed on the new charger. In this case the round connector going to it would be cut off and removed.